Problem solving guide
45
Problem Possible cause and remedy
lights up at the end
o
f a programme
There is a build-up of fluff in the airways.
Cl
ean the fluff filters.
Cl
ean the plinth filter.
See "Cleaning and care".
To switch off :
Open and close the door whil
e the dryer is
switched on.
and li
ght up after
a programme is
cancelled
An excessive amount of fluff has built up.
Cl
ean the fluff filters.
Cl
ean the plinth filter.
Clean the airways:
Cl
ean the area underneath the plinth filter.
Cl
ean the heat exchanger.
To switch off :
Switch the dr
yer off and back on again.
li
ghts up after a
programme is cancelled
The condensed water container is full or there is a
kink in
the drain hose.
Emp
ty out the condensed water container.
Check the dr
ain hose.
To switch off :
Op
en and close the door while the dryer is
switched on.
lights up The programme selector has been moved.
Select the orig
inal programme. The time remaining
will appear in the display again.
Bars flash in the display
at the end of a
pr
ogramme:
.........
The programme has finished but the laundry has not
yet cooled down.
Either r
emove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
To Next Page
Loading...
Need help?
General
