Problem solving guide
44
Problem solving guide
With the help of the following notes minor faults in the performance of the
appliance, some
of which may result from incorrect operation, can be put right
without contacting Miele.
Please note that a call-out charge will be applied to service visits where the
pr
oblem could have been rectified as described in these operating instructions.
Repair w
ork to electrical appliances should only be carried out by an
authorised Miele service technician. Repairs and other work by unqualified
persons could be dangerous. Miele cannot be held liable for unauthorised
work.
Check indicators and fault messages
Problem Possible cause and remedy
The programme is
cancelled,
lights up
This is not a fault.
In some pr
ogrammes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
Op
en and close the door to resume drying.
Use the W
arm air programme (timed drying) to dry
individual items.
flashes/lights up
aft
er the tumble dryer is
switched on and a
programme cannot be
selected
Access via a code has been activated.
See "
Programmable functions - Code".
and (e.g. )
lig
ht up after a
programme is cancelled
There is no obvious cause.
Switch the dr
yer off and then on again.
S
tart a programme.
If the programme is cancelled again and an error
message
appears, there is a fault. Contact Miele.
To Next Page
Loading...
Need help?
General
