Programmable functions
68
PIN Code
The code prevents your machine
being used without your knowledge.
When the code has been activated, you
have t
o enter a code after switching the
dryer on. Otherwise the dryer cannot be
operated.
Options
F
actory default: off
Code on
If option has been select
ed, after
switching on you will have to enter the
code before you can operate the dryer.
Using the dryer when the code is
activa
ted
After the dryer is switched on, will
flash in the
time display.
The code is and cannot be alt
ered.
Touch the sensor until a
flashes in the first position.
Co
nfirm this by pressing the
Start/
Stop butt
on.
Ent
er the two other numbers in the
same way.
The dryer is ready for use after
has
been entered and confirmed.
Conductivity
This setting should only be
a
ltered if the water is so soft that it is
likely to cause the electronics which
sense residual moisture in the
laundry to give false readings.
Important
This option should not be activated if,
despit
e the water being extremely soft
(as would be the case if a water
softener were used), its conductivity is
greater than 150 μS/cm.
O
nly activate this programmable
function for the conditions described
above.
Otherwise drying results can be
un
satisfactory.
Options
F
actory default: off
Low conductivity
To Next Page
Loading...
Need help?
General
