Problem solving guide
58
With the help of the following notes minor faults in the performance of the
appliance, some
of which may result from incorrect operation, can be put right
without contacting the Service Department.
Repair w
ork to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety
regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Messages in the display
Problem Cause and remedy
Code 000 flashes / lights
up aft
er switching on
Access via a code has been activated.
See "Settings menu, Code".
Adjust the load
The drum is empty or the
laundry is too dry.
l
ights up after a
programme is cancelled
This is not a fault.
In some pr
ogrammes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
Op
en and close the door to resume drying.
Dr
y individual items using the Warm air timed
drying programme.
Technical fault F
If restart is unsuccessful call
Service.
li
ghts up after a
programme is cancelled
No obvious cause.
Switch the dr
yer off and then on again.
S
tart a programme.
If the programme is cancelled again and an error
message
appears, there is a fault. Contact the Miele
Service Department.