Important control panel
features
Programme selector
The programme selector is used to set
the basic wash programme and the
temperature for that programme. The
light ring will go out a few minutes after
the end of the programme to save en
-
ergy.
Additional option buttons
Additional options can be added to the
basic programme.
Pressing the relevant button selects or
de-selects the particular option. The in-
dicator light comes on to show that the
additional option has been selected.
If an additional option is chosen which
is incompatible with the basic
programme then the indicator light will
go out when the button is released.
"Spin" button with indicator lights
Selecting the spin speed
The maximum spin speed which can be
selected depends on the basic
programme chosen.
Maximum
spin
speed
Basic programme
1600 COTTONS, Quick wash, Starch,
Drain/spin
1200 WOOLLENS, Separate rinse
900 MINIMUM IRON, Mixed wash
600 DELICATES
400 Silks
Press the "Spin" button to select a differ
-
ent spin speed. However, you cannot
select a spin speed higher than the
maximum allowed for the basic wash
programme chosen.
The indicator lights show the speed se
-
lected.
You can also omit the final spin
^
Press the "Spin" button to reach:
–
Rinse hold
The laundry is not spun and remains
suspended in the final rinse water.
This reduces creasing if the laundry
is not going to be removed from the
drum immediately after the end of
the programme.
To continue the programme select a
spin speed. When the programme is
finished the
Anti-crease/Finish
light
will come on. Turn the programme
selector to the
Finish
position and
press the
door
button to open the
door and remove the laundry.
–
Without spin
The laundry is not spun after the final
rinse. After the water has been
drained away the machine goes
straight into the anti-crease stage.
Spinning between the rinses is also
omitted in this setting (rinse and in
-
terim spin).
Description of the appliance
13
To Next Page
Loading...
