I Add detergent
It is important to dispense the correct
amount, because . . .
. . . too little results in the following:
–
Laundry will not be properly clean
and will in time become grey and
hard to the touch.
–
Greasy particles cling to the laundry.
–
Limescale deposits on the heater el
-
ements.
. . . too much results in the following:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an addi-
tional rinse cycle will automatically
switch in).
– A burden to the environment.
If you wish to select the
Pre-wash
additional option when using liquid
detergent, please note that the
detergent must be poured into a "liquid
detergent container" which has been
inserted into compartment j. This
container is available from the Miele UK
Spare Parts department or from your
Miele dealer.
^
Pull out the detergent drawer and
place detergent in the compartments
as follows:
i = Detergent for Pre-wash
(if selecting Pre-wash, add
1
/
4
of the total amount recom-
mended). This compartment is
also used for starch formula-
tions when starching separately.
j = Detergent for the main wash
including Soak
§ = Fabric conditioner or liquid
starch.
See section on "Detergent" for further
information on detergent and the
amount to dispense.
How to wash correctly
23
To Next Page
Loading...
