Connection to the water supply
This washing machine can be con
-
nected to a cold water supply (mains
water supply) or a hot water supply.
The washing machine must always
be connected to the mains water
supply (inlet hose with blue dots).
Cold water connection (mains water
supply)
The inlet hose with blue dots is used for
mains water connection.
Hot water connection
The inlet hose with red dots is used for
connection to the hot water supply.
Useful hints when connecting to the hot
water supply
–
The maximum temperature at the
stocpcock must not exceed 60°C.
The ideal temperature is 55°C.
–
Before connecting the washing ma
-
chine, check that no more than 5
litres of cold water flow out of the
connection point. Every extra litre of
cold water will compromise the ma
-
chine’s energy efficiency.
–
When connected to the hot water
supply, after some time the washing
machine will switch over to the mains
water supply. However, this safety
feature is not suitable for constant
use. The washing machine will use
the hot water supply thereafter but
this can lead to a poor wash result.
The conditions for connection are
described on the following pages.
Installation and connection
52
To Next Page
Loading...