Building under a continuous worktop
/ in a kitchen run
–
A special building under conversion
kit* is required.
The machine lid must be replaced by
a cover plate. To ensure electrical
safety the cover plate must be fitted.
**
N.B.**
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid, the conver
-
sion kit is not necessary. Otherwise the
conversion kit is essential.
– For installation under a work surface
900/910 mm from the floor, a raising
kit* is required.
– Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Fitting instructions are supplied with the
conversion kit.
All parts marked* are available from the
Miele Spare Parts or Sales Department.
The fitting of cover plates and stack
-
ing kits must only be undertaken by
qualified and competent persons, in
accordance with the instructions
supplied with the kit.
Washer and Dryer stack
A Miele tumble dryer can be stacked
with the washing machine. A stacking
kit* is necessary and can be purchased
from the Miele Spare Parts Department.
Please note
a Safety distance to wall:
at least 2 cm
b Height:
Stacking kit with pull-out shelf:
approx. 169 cm
Stacking kit without pull-out shelf:
approx. 170 cm
,
A washer and dryer should
never be stacked without using the
proper stacking kit. Doing so is ex
-
tremely dangerous, as the dryer may
vibrate off of the washing machine
during use.
Installation and connection
51
To Next Page
Loading...