Miele W 463 - Page 61

Follow steps to to programme
and store a setting in memory.
The programmable functions are acti
-
vated to call up further features not
shown on the control panel by using the
additional option buttons in combina
-
tion with the programme selector.
Before you begin, first ensure that:
–
The washing machine is switched off.
–
The drum door is closed.
–
The programme selector is at
Finish .
A Press the additional option buttons
Rapid and Water plus at the same
time, hold pressed in and .
B . . . Switch the machine on with the
I-ON/0-OFF button.
C Let go of all these buttons. P 0 ap-
pears in the display.
D Turn the programme selector to
DELICATES 30°C.
E The P will now flash in the display al
-
ternating with the number 2
In addition, one of the following num
-
bers will appear on the right of the dis
-
play:
1, 2, 3 or 4
F Press the START button to toggle be
-
tween the varous settings.
The number on the right of the display
shows which setting is selected.
1 = Setting 1
is selected
(increased water level in the
rinses)
2 = Setting 2
is selected
(increased water level in the main
wash and in the rinses)
3 = Setting 3
is selected
(extra rinse in the COTTONS and
MINIMUM IRON programmes)
4 = Setting 4
is selected
(increase in the water level in the
main wash and rinses and also an
extra rinse in the COTTONS and
MINIMUM IRON programmes).
G Switch the machine off with the I-ON/
0-OFF button.
The
Water plus button has now been al
-
located the setting you have chosen.
This setting will remain in memory until
another setting is programmed.
Programmable functions
61