Spinning
28
Final spin speed in wash
programmes
When a programme is selected, the
sensor control for the optimum spin
speed for that programme will be
brightly lit up in the control field.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Programme rpm
ECO 40-60 1400
Cottons 1400
Minimum iron 1200
Woollens 1200
Delicates 900
Express 20 1200
Dark garments/Denim 1200
Outerwear 900
Proofing 1200
Drain/Spin 1400
Separate rinse/Starch 1200
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than 700 rpm is selected for the
Cottons programme, an additional rinse
is introduced.
Selecting Rinse hold (final spin)
Touch the sensor control
repeatedly until the indicator
(Rinse hold) lights up.
The laundry is not spun after the final
rinse cycle and remains in the rinse
water. This helps to prevent creasing if
the laundry is not going to be removed
from the washing machine immediately
after the end of the programme.
Ending a programme with a spin
cycle
The indicator with the ideal spin speed
lights up. You can change the spin
speed with the sensor control.
Touch the sensor control.
Ending a programme without a spin
cycle
Touch the sensor control
repeatedly until the indicator
(without spin) lights up.
Touch the sensor control.
Omitting the rinse-spin and the
final spin
Touch the sensor control
repeatedly until the indicator
(without spin) lights up.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes, an extra rinse is
introduced with this setting.
To Next Page
Loading...
