Programmable functions
75
Reduce temperature
The boiling point for water is lower at
high altitudes. In order to avoid water
boiling, Miele recommend activating
the reduce temperature setting at
altitudes of more than 2000m above
sea level. The maximum temperature
is reduced to 80°C even when a
higher temperature is selected.
Options
= The reduce temperature setting
is switched off (factory default
setting)
= The reduce temperature setting
is turned on
Water plus
You can determine the amount of
water used if the Water + extra is
selected.
Selection
= More water is used in the wash
and rinse stages (factory
default setting)
= An extra rinse is carried out
= The water level in the wash
and rinse stages is increased
and an extra rinse is carried
out
Water plus level
There are three different water levels
which can be selected by activating
the Water + extra.
Options
= No higher water level (factory
default setting)
= Water level increase by 1level
when washing and rinsing
= Water level increase by 2levels
when washing and rinsing
= Water level increase by 3levels
when washing and rinsing
Maximum rinse level
The water level in the rinse cycle can
be permanently set to the highest
value.
This function is useful for allergy
sufferers as it achieves an excellent
rinse result. Water consumption will
increase.
Options
= Maximum rinse level is
switched off (factory default
setting)
= Maximum rinse level is
switched on
To Next Page
Loading...
