Miele WCA020 WCS Active - Programmable Functions; P33 Suds Cooling Function; P34 Anti-crease Function; P49 Low Water Pressure Function

Programmable functions
76
 Suds cooling
When this is activated, additional
water flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a
temperature of 70°C or higher is
selected for the Cottons programme.
Suds cooling should be activated:
- to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- where drainage pipes do not comply
with DIN 1986.
Options
 = Suds cooling is switched off
(factory default setting)
 = Suds cooling is switched on
 Anti-crease
The anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
The drum continues to turn at intervals
for up to 30minutes at the end of the
programme. The door can be opened at
any time.
Options
 = The anti-crease function is
switched off
 = The anti-crease function is
switched on (factory default
setting)
 Low water pressure
If the water pressure is below 100kPa
(1bar), the washing machine cancels
the programme and the  fault
message appears.
If the water pressure cannot be
increased, activating this function will
prevent the programme from being
cancelled.
Options
 = Low water pressure is
switched off
 = Low water pressure is
switched on (factory default
setting)