Miele WCA020 WCS Active - Problem Solving Guide; Programme Cancelled with Fault Indicator

Problem solving guide
47
The programme is cancelled and a fault indicator light lights up
in the control panel
Problem Cause and remedy
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum delivery head is 1m.
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water inlet is blocked or restricted.
 Check whether the stopcock is opened properly.
 Check whether the inlet hose is kinked.
 Check whether the water pressure is too low.
The filter in the water inlet is blocked.
 Clean the filter.
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water protection system has reacted.
 Close the stopcock.
 Call the Service Department.
and appear
alternately on the time
display and the buzzer
sounds.
There is a fault.
 Disconnect the washing machine from the
electricity supply. Switch off at the wall and
withdraw the plug from the socket, or disconnect
the fuse.
 Wait at least 2minutes before reconnecting the
washing machine to the electricity supply.
 Switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact the
Miele Customer Service Department.