Miele WCE 670 - Removing transit bars; Commissioning TwinDos

Before using for the first time
20
3. Removing the transit bars
 Failure to remove the transit bars
can result in damage to the washing
machine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in “Installation and connection”.
The following message appears in the
display:
 Remove transit bars
 Confirm with the OK sensor.
4. Commissioning TwinDos
The UltraPhase1 and UltraPhase2
values are pre-set in the standard
settings and only need to be confirmed.
The following message appears in the
display:
 TwinDos
 Confirm with OK.
The following message appears in the
display:
Set now
 To set up TwinDos now, touch the OK
sensor.
 To postpone setup until later: Touch
the  sensor until the following
appears in the display: Set later and
press OK to confirm.
Settings for compartment 
The UltraPhase1 values are pre-set in
the standard settings.
Agent for 
OK





 Confirm with the OK sensor.
Miele UltraPhase 1
OK





 Confirm with the OK sensor.
The following will appear in the display:
 Set the dosage. Observe water hardness
level
 Confirm with the OK sensor.
The dispensing quantity for
UltraPhase1 for  (hardness range I)
is pre-set.
Per load
OK




ml48
 Confirm the pre-set value with the OK
sensor or correct the value with the
 sensors and confirm this with the
OK sensor.
UltraPhase1
 Hardness level I 48 ml
 Hardness level II 60 ml
 Hardness level III 72 ml