Miele WCE 670 - Fault messages at end of programme

Problem solving guide
63
Fault messages at the end of a programme
Problem Possible cause and remedy
 Check detergent
Excessive foam has built up during washing.
 With TwinDos, check the dosage amount set.
 Reduce the amount set in 10% increments.
 Use less detergent next time and follow the
manufacturer's instructions on dosage given on
the packaging.
 Hygiene info: Run a
programme at min.
75°C or "Clean
machine'"
programme
A programme using a temperature above 60°C has
not been run for a long time.
 Turn the programme selector to Further
programmes/.
 Touch the  sensors until Maintenance appears
in the display.
 Touch the OK sensor to confirm.
The following appears in the display: Clean machine
 Touch the OK sensor to confirm.
 Run the Clean machine programme using the Miele
IntenseClean machine cleaner or a universal
powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
 Align the washing
machine
The Pre-ironing Extra which runs at the end of the
programme could not be carried out properly.
 Check whether the washing machine is aligned
correctly as described in “Installation and
connection – Levelling the machine”.
 Check whether the maximum delivery head of 1m
has been exceeded.
If the fault message appears again, contact Miele.
The washing machine can still be used, however
without the Pre-ironing Extra.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.