Settings
93
Low water pressure
If the water pressure is below 100kPa
(1bar), the programme will be
cancelled and a fault message will
appear.
If the on-site water pressure cannot be
increased, activating this function will
prevent the programme from being
cancelled.
Low water pressure is deactivated as
standard.
Anti-crease
The Anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
At the end of the programme, the drum
continues to turn at intervals for up to
30 min. The washing machine door can
be unlocked at any time by touching the
Start/Stop sensor and then opened.
Anti-crease is deactivated as standard.
Miele@home
Control the networking of your
washing machine with your Wi-Fi
network.
The following points may appear in the
submenu:
Set up
This message only appears if the
washing machine has not yet been
connected to a Wi-Fi network.
Please refer to “Before using for the first
time” for instructions on how to set up
the connection.
Deactivate (visible if Miele@home is
activated)
Miele@home remains set up, the Wi-Fi
function is switched off.
Activate (visible if Miele@home is
deactivated)
The Wi-Fi function is reactivated.
Connection status (visible if Miele@home
is activated)
The following values are displayed:
– the Wi-Fi reception quality
– the network name
– the IP address
Set up again (visible if set up)
Resets the Wi-Fi login (network) to
immediately re-establish a new
connection.
Reset (visible if set up)
– The Wi-Fi is switched off.
– The Wi-Fi connection will be reset to
the factory setting.
Miele@home is no longer set up. A new
connection setup has to be carried out
in order to use the Miele@home setting
again.
To Next Page
Loading...
