Miele WCE 670 - Page 22

Before using for the first time
22
Settings for compartment 
The UltraPhase2 values are pre-set in
the standard settings.
After the UltraPhase 1 cartridge has
been pushed in, the display message
switches to:
Agent for 
OK





 Confirm with the OK sensor.
Miele UltraPhase 2
OK




 Confirm with the OK sensor.
The dispensing quantity for
UltraPhase2 for  (hardness range I)
is pre-set.
Per load
OK




ml36
 Confirm the pre-set value with the OK
sensor or correct the value with the
 sensors and confirm this with the
OK sensor.
UltraPhase2
 Hardness level I 36 ml
 Hardness level II 45 ml
 Hardness level III 54 ml
The following appears in the display:
 Insert 
 Remove the foil or the stopper from
the detergent cartridge.
 Push the UltraPhase2 detergent
cartridge into compartment2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
 "TwinDos" is set. Can be changed in
'Settings'
 Confirm with the OK sensor.
 Close the TwinDos access panel.