Miele WDD 030 User Manual

Problem solving guide
48
An error indicator light lights up in the control panel and the
programme was cancelled
Problem Possible cause and remedy
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the pump.
 The maximum drain height is 1m.
The fault indicator light
 lights up,  and 
appear alternately in the
time display and the
buzzer sounds.
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
 and  alternately
appear in the time
display and the buzzer
sounds.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the mains electricity supply.
 Then switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact Miele.

Miele WDD 030 Specifications

General

Brand	Miele
Model	WDD 030
Category	Washer
Language	English