Miele WDD 030 - Customizing Machine Functions; Entering Programming Mode; Navigating Programmable Functions

Programmable functions
71
The programmable functions are used
to alter the machine's electronics to
suit changing requirements.
Programmable functions can be
altered at any time.
Programming is carried out in 8 steps
(, ,  ... ) using buttons and
sensors.
Accessing the programming
level
Before you begin, ensure the following:
– The washing machine is switched on
(the programme selector is pointing
to a wash programme).
– The washing machine door is open.
 Touch the Start/Stop sensor and
hold it down during step .
 Close the washing machine door.
Wait until the Start/Stop sensor lights
up constantly ...
 ... and then release the Start/Stop
sensor.
After approx. four seconds,  will light
up in the time display.
Choosing and selecting the
programmable function
The number of the programmable
function will appear in the display as 
and a number: e.g. .
 Touch the  or  sensor to scroll to
the next or previous programmable
function:
Programmable functions
 Keypad tone
 PIN Code
 Control panel standby status
 Washing machine standby
status
 Memory
 Longer pre-wash Cottons
 Soak duration
 Gentle action
 Reduce temperature
 Water plus
 Water plus level
 Maximum rinse level
 Suds cooling
 Anti-crease
 Backlight brightness dimmed
 Confirm the selected programmable
function by pressing the Start/Stop
sensor.