Programmable functions
74
Control panel standby
status
To save energy the time display and
sensors will go out after 10 minutes,
and only the Start/Stop sensor will
flash slowly.
Options
= Off
The time display and sensors
will remain lit up while the
washing machine is switched
on
= On (factory default setting)
The time display and sensors
will switch off after 10 minutes
if
– no further selection is made
after switching the machine
on
– the programme is started
However; the time display and
sensors will remain lit up for 10
minutes after a Delay start time
has elapsed, after the end of a
programme, or at the end of
the anti-crease phase.
Washing machine standby
status
The washing machines switches itself
off automatically. This occurs after the
end of the programme/anti-crease
phase, or after being switched on if no
further selection is made.
Options
= The washing machine will
switch itself off after 15
minutes (factory default
setting)
= The washing machine will
switch itself off after 20
minutes
= The washing machine will
switch itself off after 30
minutes
Memory
The washing machine will save the
last settings (temperature, spin speed
and some of the Extras) selected for a
programme after the programme has
started.
When the programme is chosen again,
the saved settings will appear in the
display.
Options
= Memory is switched off
(factory default setting)
= Memory is switched on
To Next Page
Loading...
