Miele WTF 130 WPM User Manual

WASHING AND DRYING
65
After each washing or drying
programme
 Open the drum door fully.
 Caution! The metal cap is hot
after drying.
Do not touch the metal cap located
on the inside of the door glass.
 Unload the drum.
Laundry left in the drum could shrink,
discolour or suffer damage in the
next washing or drying programme.
Check that all items have been re-
moved from the drum.
 Check the door seal for foreign ob-
jects. Remove fluff from the seal and
from the door glass after drying.
Tip: Leave the door slightly open to al-
low the drum to dry.
 Switch the washer-dryer off with the
 button.
Tip: Leave the detergent dispenser
drawer slightly open to allow it to dry.
"Rinse out fluff" programme
During drying fluff can collect in the
drum and also in the suds container.
Run the Rinse out fluff programme be-
fore the machine is used again so that
fluff cannot be deposited on the next
load or cause a blockage.
The Rinse out fluff programme must
not be used for rinsing laundry. Make
sure there are no pieces of laundry in
the drum before starting the pro-
gramme.
 Switch the washer-dryer on.
 With the programme selector dial set
to the Further programmes position,
select the Rinse out fluff programme.
Do not use detergent.
 Press the Start/Stop button.
Any fluff will be rinsed away within a
few minutes.
 If necessary wipe any remaining fluff
off the door seal and porthole glass.
 Switch the washer-dryer off.

Miele WTF 130 WPM Specifications

General

Door hinge	Right
Control type	Buttons, Rotary
Loading type	Front-load
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Half-load	-
Drying capacity	4 kg
Washing capacity	7 kg
Delay start (max)	24 h
Spin-drying class	A
Maximum spin speed	1600 RPM
Noise level (wash)	- dB
Water consumption washing per cycle	90 L
Energy consumption washing per cycle	- kWh
Water consumption washing & drying per cycle	- L

Weight and Dimensions

Depth	636 mm
Width	596 mm
Height	850 mm