Miele WTF 130 WPM User Manual

What to do if...
76
A message appears in the display at the end of the programme
Message Cause and remedy
 Check filter + jet
The pumps are dirty.
 Clean the pumps as described in "Problem solving
guide - Opening the door in the event of a blocked
drain outlet and/or power failure".
 Start the programme again after cleaning the
pumps.
The jet in the top of the door ring is blocked with fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Start the programme again after cleaning the jet.
If the fault message appears again, contact the Ser-
vice Department. The washer-dryer can still be used
but with reduced functionality.
 Align the machine
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
 Check that the washer-dryer is aligned correctly as
described in "Installation and connection - Level-
ling the machine".
 Check whether the maximum delivery height of 1.0
m has been exceeded.
If the fault message appears again, contact the Ser-
vice Department. The washer-dryer can still be used
but with reduced functionality.
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the OK sensor.

Miele WTF 130 WPM Specifications

General

Door hinge	Right
Control type	Buttons, Rotary
Loading type	Front-load
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Half-load	-
Drying capacity	4 kg
Washing capacity	7 kg
Delay start (max)	24 h
Spin-drying class	A
Maximum spin speed	1600 RPM
Noise level (wash)	- dB
Water consumption washing per cycle	90 L
Energy consumption washing per cycle	- kWh
Water consumption washing & drying per cycle	- L

Weight and Dimensions

Depth	636 mm
Width	596 mm
Height	850 mm