Miele WTF 130 WPM User Manual

What to do if...
79
General problems with the washer-dryer
Problem Cause and remedy
At the end of the pro-
gramme there is still li-
quid in the capsule.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
 Clean the small pipe.
This is not a fault. For technical reasons a small
amount of water will remain in the capsule.
There is water next to
the capsule in the fabric
conditioner compart-
ment.
The Cap  sensor was not activated or an empty
capsule was not removed at the end of the last pro-
gramme.
 Make sure that you remember to activate the Cap
 sensor the next time you insert a capsule.
 Remove and then dispose of the empty capsule at
the end of each programme.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
 Clean the small pipe.
The laundry has not
been spun properly and
the laundry is still wet.
The machine detected an imbalance during the final
spin cycle and reduced the spin speed automatically.
 Include both large and small items in the load as
this will give better distribution during spinning.
The display is dark. The display has switched off automatically to save
energy (Standby mode).
 Press a button. Standby comes to an end.
The time left duration in
the display fluctuates.
The countdown time adapts constantly to the current
washing and drying process.

Miele WTF 130 WPM Specifications

General

Door hinge	Right
Control type	Buttons, Rotary
Loading type	Front-load
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Half-load	-
Drying capacity	4 kg
Washing capacity	7 kg
Delay start (max)	24 h
Spin-drying class	A
Maximum spin speed	1600 RPM
Noise level (wash)	- dB
Water consumption washing per cycle	90 L
Energy consumption washing per cycle	- kWh
Water consumption washing & drying per cycle	- L

Weight and Dimensions

Depth	636 mm
Width	596 mm
Height	850 mm