EasyManua.ls Logo

Migomag SIM 200 LCD - Page 9

Migomag SIM 200 LCD
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Migomag SIM 200 LCD
Model No ASIM200LCD
6
• Use protecve cylinder cap whenever possible
5. Proper Care, Maintenance and Repair
• Always have power disconnected when working on internal components
• Do not touch or handle PC board without being properly grounded with a wrist strap.
Put PC board in stac proof bag to move or ship
• Do not put hands or ngers near moving parts such as drive rolls of fan
MOM SIM 200 USE AND CARE
• Do not modify the MOM SIM 200 LCD in any way. Unauthorized modicaon may
impair the funcon and/or safety and could aect the life of the equipment. There are
specic applicaons for which the MOM SIM 200 LCD was designed
• Always check of damaged or worn out parts before using the MOM SIM 200 LCD.
Broken parts will aect the MOM SIM 200 LCD operaon. Replace or repair damaged
or worn parts immediately
• Store idle MOM SIM 200 LCD. When MOM SIM 200 LCD is not in use, store it in a
secure place out of the reach of children. Inspect it for good working condion prior to
storage and before re-use
Noce:
• If the welder connues to work for to long, the (Protecon Indicator) on the panel
would be on, indicang that the inner temperature rise inside the welder had exceed
the designed permied temperature. At this me, stop the welding work, wait unl
the welder has cooled inside and the (Protecon Indicator) has turned o, then
connue to work again
• Cut o the power switch and gas cylinder before leaving the welding place temporarily
or aer the welding worked nished
• Welders should wear canvas work clothes and welding face shield to prevent arc light
and heat radiaon
• Put light-proof screen around the work area to prevent others inuenced by the arc
lights
• Flammable, explosive items could not be put near the welding area
• Every outlet of the welder should be connected and earthed correctly
Noce: The cover protecon degree of the MOM series SIM 200 LCD welder is IP21S.
When the welder is operated, do not insert nger or round sck diameter less than
12.5mm (especially metal sck) into the welder; Do not allow to press heavily onto the
welder.