22
How to change the stick mode and adjust the stick tension, how to change the stick
length
■ Tools needed: 3 mm and 2 mm hex screwdrivers, small Philips screwdriver, pliers.
■ Turn off your VBar Control transmitter
■ Remove the neck strap.
■ Put the VBar Control transmitter face down on a soft surface.
■ Remove the six screws M3x20 mm to take off the bottom case.
■ Flip the still-closed transmitter 90° to the left, carefully start opening VBar Control like a
book.
■ Carefully disconnect the switch wire there and open the VBar Control fully like a book.
The screws will fall out of the bottom case.
■ If you nd it easier, also disconnect the second switch and the vibration alarm motor.
■ Do not touch the main board!
■ Locate the spring tensioner of the former elevator stick (next to the battery, to the left or
to the right).
■ Gently unhinge the spring and remove both the plastic holder and the spring.
■ Remove the metal bracket by gently pulling it out, away from where the spring was at-
tached.
■ Unscrew the metal brake from the former throttle stick.
■ Unscrew the plastic brake on one side and unhinge it on the other side.
■ Carefully unplug the wire going through the plastic brake and carefully unthread it through
the opening in the plastic brake.
■ Re-connect the wire.
■ Place the metal bracket 180° from it’s original position on the other side, under the ele-
vator stick to come.
■ Mind that everything is rotated 180° compared to where you dismounted the parts.
■ Put the plastic holder in the slot there, and hinge the spring to the bracket and the plastic
holder.
■ Carefully unplug the connector on the throttle stick to come that will have to go through
the plastic brake you have removed on the other side, thread it through the brake, and
re-connect it.
■ Fix the plastic brake by hinging it on one side and screwing it in place.
■ Fix the metal brake and tighten to your liking.
■ Use the inner holes for a smooth brake feeling, or the outer holes for a stepped brake
feeling.
■ Adjust the springs on the other three sticks to your liking.
■ Carefully close the VBar control again, and re-connect the lower switch wire. Should you
have disconnected the other switch wire and the vibration alarm motor, too, reconnect
them before closing the VBar Control.
To Next Page
Loading...
Need help?
General
