Milesight AM103 - Page 10

10
Session Key
Spread Factor
If ADR is disabled, the device will send data via this spread factor.
Confirmed Mode
If the device does not receive ACK packet from network server, it will resend
data 3 times at most.
Rejoin Mode
Reporting interval ≤ 30 mins: the device will send specific amount of
LoRaMAC packets to check connection status every 30 mins; If there is no
reply after specific amount of packets sent, the device will re-join.
Reporting interval > 30 mins: the device will send specific amount of
LoRaMAC packets to check connection status every reporting interval; If there
is no reply after specific amount of packets sent, the device will re-join.
ADR Mode
Allow network server to adjust datarate of the device.
Tx Power
Transmit power of the device.
RX2 Data Rate
RX2 data rate to receive downlinks.
RX2
Frequency/MHz
RX2 frequency to receive downlinks.
Note:
1) Please contact sales for device EUI list if there are many units.
2) Please contact sales if you need random App keys before purchase.
3) Select OTAA mode if you use Milesight IoT cloud to manage devices.
4) Only OTAA mode supports rejoin mode.
LoRaWAN Frequency Settings:
Go to “Settings -> LoRaWAN Settings” of ToolBox App to select supported frequency and select
channels to send uplinks. Make sure the channels match the LoRaWAN
®
gateway.