To Next PageTo Next Page
Need help?Do you have a question about the Miller Dynasty 400 and is the answer not in the manual?
General| Pulse Frequency | 0.5 - 500 Hz |
|---|---|
| Input Power | 50/60Hz |
| Dimensions | 12.5 in (318 mm) |
| Processes | TIG, Stick |
| Frequency Range | 20-400Hz |
Explains warning symbols used in the manual.
Details hazards associated with arc welding processes.
Details hazards like hot parts, fumes, noise, and EMF effects.
Covers cylinder safety, installation risks, and HF interference.
Explains how to connect input power for 400 and 800 CE models.
Explains how to connect 1-phase input power.
Details connecting input power for 800 models.
Explains connecting single-phase input power for 800 models.
Identifies and explains the controls on the Dynasty front panel.
Identifies and explains the controls on the Maxstar front panel.
Guides on accessing and navigating the control panel menu.
Identifies and explains the controls for 28-pin advanced automation.
Details controls for Process Selection and Gas/DIG.
Guides on accessing and navigating the user setup menu.
Guides on accessing and navigating the Tech Menu for advanced settings.
Explains output control and trigger operation methods.
Explains how to use lockout functions to restrict access to settings.
Defines the different lockout levels and their adjustability.
Outlines routine maintenance tasks and schedules.
Provides a table to diagnose and resolve common troubleshooting issues.
Describes the Lift-Arc and HF TIG start methods.
Explains how to use and adjust the pulser control for TIG welding.
Guides on changing programmable TIG start parameters.
Provides a chart for selecting electrodes and amperage for Stick welding.
