Need help?Do you have a question about the Miller HF-15-1 and is the answer not in the manual?
General| Brand | Miller |
|---|---|
| Model | HF-15-1 |
| Category | Welding System |
| Language | English |
Details Miller Electric Mfg. Co.'s warranty obligations, limitations, and exclusions for new equipment.
Details how to adjust the intensity and its effect on radio interference.
Explains the power switch for energizing the unit and a caution about residual power.
Describes the adjustable timer for post-flow of gas and water after arc extinguishes.
Provides step-by-step instructions for adjusting spark gap settings using a feeler gauge.
A table listing common problems, their likely causes, and recommended solutions.
Outlines necessary information for proper installation and FCC compliance, including keeping the certificate with equipment.
Identifies four ways interfering radiation can escape from a welding machine installation.
Specifies conduit and shielding requirements for primary power service to ensure proper installation.
Details grounding procedures for the welding machine case and work terminal.
Advises on keeping welding leads short and close together to minimize direct weld lead radiation.
Explains rules for wiring within the HFI zone to prevent pick-up and reradiation of interference.
Defines a "good ground" and specifies requirements for ground rods and connections.
To Next Page
