Need help?Do you have a question about the Miller Invision 354MP and is the answer not in the manual?
General| Output Current Range | 5 - 350 A |
|---|---|
| Output Voltage Range | 10 - 38 V |
| Input Voltage | 208 V, 220 V, 230/240 V, 380 V, 400 V, 415 V, 440 V, 460/480 V, 500 V, 575 V, 3-Phase Power |
| Duty Cycle | 60% at 350 A |
| Dimensions | 12.5 in |
| Welding Processes | MIG, Pulsed MIG, Flux-Cored, Stick, DC TIG |
Identifies and explains hazards associated with arc welding processes.
Details safety symbols for installation, operation, and maintenance procedures.
Lists key safety standards and regulations relevant to welding equipment.
Explains duty cycle limitations and potential overheating issues.
Outlines the procedure for safely connecting the input power to the unit.
Explains the synergic control system and its four modes of operation.
Details how waveform components influence arc characteristics and burn-off rate.
Lists and explains error codes that may appear on the unit's display.
Offers solutions for common operational problems and troubleshooting steps.
To Next Page