TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1...................................
1-1. Symbol Usage 1........................................................................
1-2. Arc Welding Hazards 1..................................................................
1-3. Additional Symbols For Installation, Operation, And Maintenance 3.............................
1-4. California Proposition 65 Warnings 4.......................................................
1-5. Principal Safety Standards 4.............................................................
1-6. EMF Information 4......................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 5............................
2-1. Symboles utilisés 5.....................................................................
2-2. Dangers relatifs au soudage à l’arc 5......................................................
2-3. Dangers supplémentaires en relation avec l’installation, le fonctionnement et la maintenance 7......
2-4. Proposition californienne 65 Avertissements 8...............................................
2-5. Principales normes de sécurité 9..........................................................
2-6. Informations relatives aux CEM 9.........................................................
SECTION 3 − DEFINITIONS (CE Models) 11........................................................
3-1. Warning Label Definitions 11..............................................................
3-2. WEEE Label (For Products Sold Within The EU) 12...........................................
3-3. Symbols And Definitions 13...............................................................
SECTION 4 − INSTALLATION 14..................................................................
4-1. Important Information Regarding CE Products (Sold Within The EU) 14...........................
4-2. Serial Number And Rating Label Location 14.................................................
4-3. Specifications 15........................................................................
4-4. Volt-Ampere Curves 16...................................................................
4-5. Duty Cycle And Overheating 17............................................................
4-6. Selecting A Location 18...................................................................
4-7. Weld Output Terminals And Selecting Cable Sizes* 19.........................................
4-8. Remote 14 Receptacle Information 20.......................................................
4-9. Automation 10-Pin Connection (LX Models) 21...............................................
4-10. Typical Automation Application 21..........................................................
4-11. Gas Connections 22.....................................................................
4-12. TIG HF Impulse/ Lift-Arc DCEN (Direct Current Electrode Negative) Connections 22...............
4-13. Stick DCEP (Direct Current Electrode Positive) Connections 23.................................
4-14. TIGRunner Connections 24...............................................................
4-15. Electrical Service Guide 25................................................................
4-16. Connecting Input Power 26................................................................
SECTION 5 − OPERATION 28....................................................................
5-1. Controls 28.............................................................................
5-2. Encoder Control 29......................................................................
5-3. Amperage Control 29.....................................................................
5-4. Ammeter And Parameter Display 29........................................................
5-5. Voltmeter 30............................................................................
5-6. Process Control 30......................................................................
5-7. Lift-ArcE And HF TIG Start Procedures 31...................................................
5-8. Output Control 32........................................................................
5-9. Pulser Control (DX And LX Models) 33......................................................
5-10. Sequencer Controls (DX Models Only) 34...................................................
5-11. Adjust Controls (Preflow/Post Flow/DIG/Purge) 35............................................
5-12. Spot Time Control (Reconfigured RMT 2T HOLD Output Selection) 36...........................
5-13. Factory Parameter Defaults And Range And Resolution 36.....................................
5-14. Resetting Unit To Factory Default Settings (All Models) 37......................................
5-15. Arc Timer/Counter Display 38..............................................................
To Next Page