Miller Multimatic 235 - Page 45

. A complete Parts List is available at www.MillerWelds.com
OM-283935 Page 41
6-12. Factory Reset (Menu 9 Of 13)
1 Lower Right Inside (−) Button
2 Lower Right Outside (+)
Button
3 Auto-Set Button
. A Factory Reset will reset the
primary logs data, process logs
data, error logs data, selected
process, and all process set-
tings. Motor calibration set-
tings, Spoolmate Calibration
settings, and software informa-
tion will all be retained.
Follow instructions in Section 6-3 to
enter the setup menu.
To perform a Factory Reset, press
the Auto−Set button.
To exit menu, simultaneously press
and release the lower left outside
(−) button and lower right outside
(+) button, or turn unit off and on.
Ref. 281104-C
1
2
3
6-13. Display Software (Menu 10 Of 13)
. Display Software information is
for factory and service use
only.
Follow instructions in Section 6-3 to
enter the setup menu.
To exit menu, simultaneously press
and release the lower left outside
(−) button and lower right outside
(+) button, or turn unit off and on.
Ref. 281104-C