Miller T94 Series User Manual

OM-255503 Page 16
5-6. Lens Delay Control
(R)
MEMO
(
B
)
1
2
1 2
3
1 Mode Button
2 Adjust Button
3 Increase (+) And Decrease (–) Buttons
Select Delay by pressing the Adjust button.
Use the + / - buttons to adjust the time for
the lens to switch to the clear state after
welding or cutting.
The delay is particularly useful in eliminating
bright after-rays present in higher amperage
applications where the molten puddle re-
mains bright momentarily after welding. Use
the + / - buttons to adjust delay from 0 to 10
(0.1 to 1.0 second).
The delay ranges for each mode are as
follows:
Weld, Cut, X-Modes - 0 - 10
Grind Mode - No delay adjustment
F
There is no lens delay adjustment in
the Grind mode.
Lens Delay Adjustment Procedure
l Press Mode (On/Off) button to turn lens
On. Helmet control display will appear.
l Press Mode button to select desired
function: Weld, Cut, or X-Mode.
l Use Adjust button to select delay, and
then adjust to desired delay using + / -
buttons.
l Begin welding or continue with other
lens adjustments.

Miller T94 Series Specifications

General

Brand	Miller
Model	T94 Series
Category	Motorcycle Accessories
Language	English