To Next Page
H
Herbert MaldonadoJul 27, 2025
How to fix a cracked torch body on Miller Welding System?
- JJessica WellsJul 27, 2025
If the torch body is cracked, replace it.
How to fix a cracked torch body on Miller Welding System?
If the torch body is cracked, replace it.
What to do if cables and cords of Miller Welding System are cracked?
If you find that the cables and cords are cracked, you should repair or replace them.
What to do if labels are damaged on Miller XMT 350 Welding System?
If the labels are damaged or unreadable, you should replace them.
General| Rated Output | 350 A at 34 VDC, 60% duty cycle |
|---|---|
| Welding Amperage Range | 5 - 425 A |
| Efficiency | 85% |
| Power Factor | 0.95 |
| Protection Class | IP23 |
| Processes | Stick, TIG, MIG, Flux-Cored |
| Input Power | 208/230/460 V, 3-Phase, 50/60 Hz |
Details potential hazards associated with arc welding processes.
Provides technical data and performance parameters of the unit.
Explains the unit's duty cycle and overheating protection mechanisms.
Provides recommendations for electrical service requirements for safe operation.
Step-by-step instructions for connecting single-phase input power.
Step-by-step instructions for connecting three-phase input power.
Identifies and explains the functions of the front panel controls and displays.
Details the settings for various welding processes and output controls.
Guides on pairing an ArcReach device with the power source.
Explains Lift-Arc TIG welding mode with output ON.
Details TIG welding mode with remote ON/OFF control.
Provides solutions for common problems encountered during operation.
