To Next PageTo Next PageWhat to do if pressing the gun trigger does not energize the Miller Welding System feeder?
Ensure the plug from the gun control cable is securely inserted into the gun control receptacle on the feeder. If equipped, have a Factory Authorized Service Agent inspect the optional water flow switch.
Why does the wire feed erratically on my Miller XR-AlumaPro?
To resolve erratic wire feeding in your Miller Welding System, check the conduit for any wear or obstructions, replacing it if necessary. Verify the contact tip is the correct size and replace it if needed. Also, check the pressure roll tension setting.
What to do if Miller Welding System wire feeds, but welding wire is not energized?
To troubleshoot a Miller Welding System where the wire feeds, but the welding wire is not energized, begin by cleaning and tightening all power connections. Then, check the operation of the welding power source.
What to do if there is no wire feed at gun, but the feeder is operating properly on Miller XR-AlumaPro Welding System?
If your Miller Welding System's wire feeder is operating properly but there's still no wire feed at the gun, you can try the following: reset the circuit breaker in the feeder/control box and check for shorts in the motor leads. Check the potentiometer with a meter and replace it if necessary, and check the motor and potentiometer wires for continuity.
Why does Miller Welding System wire feed one speed only?
If your Miller Welding System wire feeds at only one speed, check the potentiometer with a meter and replace it if necessary. Also, check the continuity of the welding gun wire feed speed potentiometer and replace it if necessary.
General| Brand | Miller |
|---|---|
| Model | XR-AlumaPro Series |
| Category | Welding System |
| Language | English |
Details dangers related to arc welding processes and necessary precautions.
Step-by-step guide for threading wire for AlumaPro and Millermatic 350P wire feeders.
Instructions for threading wire through the XR-Control feeder.
Guides the final steps of threading wire from the feeder to the gun.
Describes the functions of the trigger and wire speed control on the gun.
Details setting the pressure roll tension for different wire types.
Outlines daily, weekly, and monthly maintenance checks for push/pull guns.
Step-by-step guide on cleaning the gun liner for XR-AlumaPro guns.
Provides a table of common problems and their remedies.
