Table of Contents
PELLERIN MILNOR CORPORATION
Table of Contents
Sections Figures, Tables, and Supplements
Chapter 1. Controls
1.1. Controls on Mark VI Non-Tilting Washer-extractors
(Document BICWCO02)
1.1.1. Where are the Controls? Figure 1: Locations of Controls
1.1.2. Where do I Connect the Data Storage Device? Figure 2: Serial Connection for Data
Transfer
1.1.3. What are the Operating Controls? Figure 3: Mark V Controls
Figure 4: Mark VI Control Panel
Figure 5: Keypad
1.1.4. What are the Loading Controls?
1.1.5. What does this Switch do? Figure 6: Mildata/Local Selector switch
Figure 7: Manual Supply Flush button
Figure 8: Autospot selector switch
Chapter 2. Normal Machine Operation
2.1. Operating Instructions for Plant Personnel (Document
BICWCO03)
2.1.1. Start Here for Safety
2.1.2. Check Switch Settings
2.1.3. How do I Load a Non-tilting Machine?
2.1.4. How do I Select a Formula? Figure 9: Selecting a Local or Remote
Formula
2.1.4.1. Selecting a Local Formula Figure 10: Select Local Formula Screen
Supplement 1: About Load Weight and
Metered Water
Figure 11: Entering Load Weight for
Metered Water
2.1.4.2. Selecting a Mildata Formula Figure 12: Select Remote Formula Screen
2.1.4.3. Entering Mildata Batch Codes Figure 13: Batch Data for Remote Formula
Operation
2.1.5. Start the Selected Formula Supplement 2: Chemical Injections with
the Operator Signal
2.1.6. What Does the Run Display Tell Me? Figure 14: How to Read the Run Display
2.1.6.1. Formula and Step Information Table 1: Machine Status Messages
2.1.6.2. Basket Rotation
2.1.6.3. Bath Temperature and Level
2.1.6.4. Formula Steps and Chemical Injection
2.1.7. Unload the Machine Figure 15: Typical Message when Formula
Ends
2.1.7.1. For any End Code
5
To Next Page
Loading...
