Milnor 76028CBW - Page 35

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 4: Fluid Containers
Examine. Add fluid if necessary and keep components clean to prevent damage.
Mark
1
2 3 4 5 6
Do this each
Component
More Data. See also Section 3.1.4
“Lubricant Identification and Procedures”
For the next three items, see Figure 22
first 100
hours
Remove used oil. Add oil 220 (Table 10). See
Section 3.1.4.3
x 1200 hours Add oil 220 (Table 10) if necessary.
x 2400 hours
speed reducer (gear reducer)
Remove used oil. Add oil 220 (Table 10).
x
day* Add oil MCL (Table 10) if necessary. Figure
23
x 2400 hours
reservoir for chain mist oiler
Remove used oil. Remove contamination
from reservoir and suction tube. Add oil MCL
(Table 10)
Table 5: Components that Become Worn
Examine. Tighten or replace if necessary, to prevent shutdowns and unsatisfactory performance.
Speak to your dealer for replacement parts
Mark
1
2 3 4 5 6
Do this each
Component More Data
x 200 hours drive belts and pulleys See Supplement 2 and Figure 10
x 200 hours tubes and hoses Examine hoses and hose connections for
leaks.
x 1200 hours drive couplings See Figure 20
x 200 hours support wheels, tracking
wheels (guide wheels)
See Figure 21
x 200 hours drive chains, chain tension
mechanisms, sprockets
See Figure 24
x 200 hours water seals Look for leaks at the load chute and between
modules or units. It is necessary to repair a
large leak. Speak to your dealer or
Milnor.This is not routine maintenance.
Table 6: Bearings and Bushings. See Table 7 for Motors.
Apply grease to these components to prevent damage.
Mark
1
2 3 4 5 6
Do this each
Component
More Data. See also Section 3.1.4
“Lubricant Identification and Procedures”
x 600 hours support wheels Add 0.12 oz (3.5 mL) of grease EPLF2
(Table 10).
x 600 hours tracking wheels (guide
wheels)
Add 0.12 oz (3.54 mL) of grease EPLF2
(Table 10).
x 600 hours drive coupling chain Put a light coat of grease CG (Table 10). See
Figure 20
31