36
Pellerin Milnor Corporation
Figure 23. Suspension Components on Each Side of Rubber Spring-resting Washer-extractor (see
Section 3.3.3 : About the Shock Absorbers, page 35)
Rubber Spring - two on each
side
Shock Absorbers - 48040_
model shown
Shock Absorbers - 68036_
model shown
Legend
1...If cracks occur in the rubber spring, it is necessary to replace this component. Speak to your dealer or Mil-
nor
®
. This is not routine maintenance.
2...If oil is present here, the seals are worn. Replace the shock absorber.
3...If the rubber in a connector is very worn or missing, replace the shock absorber.
Routine Maintenance
To Previous Page
Loading...
Need help?
General