– 3.39 –
SKEW CHECK :
Setting Description
0 to 99 mm Set the range of the sheet feeding error when performing continuous copy.
In case performing continuous copy on roll sheet, it may be misaligned by degrees for the sheet
direction. In case the TP1 mark misaligned over the range, cutting performance is temporally stopped.
Push on the [ENTER] key after altering the sheet feeding error.
Push on the [ENTER] key after moving the light pointer to the position as the pictures below for re-
starting the mark detect. In case not detecting the marks, set the value to “0”.
Mark: TYPE1 Mark: TYPE2
Mark standard1
Mark standard1
Starting point for mark detect
To Next Page
Loading...
