MIMAKI CG-60SL Supplement For The Basic Operation Manual

Supplement for the Basic Operation manual
MIMAKI ENGINEERING CO., LTD.
D202064-10
The following functions are added from firmware version 1.80.
Please read this manual and fully understand it before using the device.
If you have any question, contact your local distributor.
This manual correspond to the models as firmware version 1.80 or later.
When turning on the power, you can confirm the firmware version.
Table of Contents
Make the media without uncut area ................................................................................ 2
Other Convenient Settings ............................................................................................... 3
Error message ................................................................................................................... 4

MIMAKI CG-60SL Specifications

General

Type	Cutting Plotter
Cutting Method	Drag Knife
Maximum Media Thickness	0.25 mm
Blade Type	Standard Blade
Interface	USB 2.0
Power Requirements	50/60 Hz
Weight	25 kg
Maximum Cutting Speed	500 mm/s
Cutting Force	20 – 250 g
Power Supply	AC 100-240 V
Operating Temperature	5 – 35 °C
Operating Humidity	35-80% RH (non-condensing)
Dimensions (W x D x H)	950 mm x 430 mm x 330 mm (37.4 in x 16.9 in x 13.0 in)