MIMAKI CJV330 Series Guide

- 13 -
Even if register marks are detected with Supported
Print & Cutters, ID cut is not performed.
Is PC and Supported Print & Cutters con-
nected via USB or Ethernet?
Connect with USB or Ethernet.
Is Supported Print & Cutters properly reg-
istered in CuttingLink - Server?
Confirm the following contents on the [Cut-
ting Device Manager] tab of CuttingLink -
Server.
(1) Is [Output Port] the same as what is
physically connected? (USB/Ethernet)
(2) Is the serial number displayed in
[Device Name] the same as the serial
number of the Supported Print & Cut-
ters main unit?
Register Supported Print & Cutters with Cut-
ting -Link.( P.5 "Register Supported Print
& Cutters with CuttingLink.")
Is the ID cut setting correct in Supported
Print & Cutters?
Check the following contents on the oper-
ation panel.
• Is [CUTTING] - [MARK DETECTION] -
[FORM] and [SIZE] the same as the print
register mark data?
Set the same register mark shape and size
as the print register mark data with Sup-
ported Print & Cutters.
Contact the call center.
When multiple register marks with different IDs are
attached, does not cut continuously.
Is the shape and size of the register mark
printed all the same?
Make all shapes and sizes of register marks
same.
Are the values for [CUTTING] - [MARK
DETECTION] - [DETECT AREA] appropri-
ate on Supported Print & Cutters?
Enter the correct set [cutting] - [register mark
detection] - [detection area] with UCJV 300/
150. ( P.19 "Set the register mark detec-
tion area on the operation panel of Sup-
ported Print & Cutters.")
Contact the call center.
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes

MIMAKI CJV330 Series Specifications

General

Brand	MIMAKI
Model	CJV330 Series
Category	Printer
Language	English