MIMAKI SWJ-320 S2 - Page 105

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.3.8 P.2
4.3.8 Checking path length(for right and left) of feeding surface
R.1.0
1
2
3
4
5
6
7
8
3. Mark wire with the tape over the platen.
Remove wire and check the path length for the left side in the
same way.
 Checking procedure (Rear side)
1. Remove the pinch roller at the left edge and attach the wire tip
with the pinch roller shaft.
Fold back
Fold back the same path as the media and check the
path length (difference between black wire and red
wire) for the left side with the right front-basis (dif-
ference between black wire and red wire = 0).
<If the left path length is different.>
Displace the gear of the tension bar by tooth up and
down and adjust the path length.
Refer to “INSTALLATION GUIDE [4.2 Assembling
the Stands and the Device]-[13. Attach the take-up
tension bar.]”
Pinch roller
OPT-J0274
When you push the pinch roller from above, it comes
off.
Push
MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Checking path length(for right and left) of feed-
Model SWJ-320S Issued 2013.03.08 Revised F/W ver 1.0 Remark
1.0
Rev.