MIMAKI SWJ-320 S2 - Page 106

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.3.8 P.3
4.3.8 Checking path length(for right and left) of feeding surface
R.1.0
1
2
3
4
5
6
7
8
2. Pass wire as indicated.
Fold back the path and pull wire up over the platen.
3. Mark wire with the tape over the platen.
Remove wire and check the path length for the right side in the
same way.
ピンチローラ
OPT-J0274
Tensio bar
Return path
Feeding roller
Fold back the same path as the media and check the
path length (difference between black wire and red
wire) for the left side with the right front-basis (dif-
ference between black wire and red wire = 0).
<If the left path length is different.>
Displace the gear of the tension bar by tooth up and
down and adjust the path length.
Refer to “INSTALLATION GUIDE [4.2 Assembling
the Stands and the Device]-[15. Attach the feeding
tension bar.]”
MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Checking path length(for right and left) of feed-
Model SWJ-320S Issued 2013.03.08 Revised F/W ver 1.0 Remark
1.0
Rev.