© 2013 MIMAKI ENGINEERING CO.,LTD. 6.8.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Heater relations > Temperature controller
Model
SWJ-320S
Issued
2012.07.19
Revised F/W ver
Remark
1.0
6.8.1 Temperature controller
Work procedures
1. Turn off the main power supply and remove the power plug
from the main body.
2. Open the left electrical BOX cover.
3. Disconnect all of the cables connected on the backside of con-
troller.
4. Remove the mounting adapter by widening the top and bottom
hook parts of mounting adapter by a flat-blade screwdriver or
the like and pulling it to the front direction.
キ
5. Reverse the disassembly procedure for reassembly.
At connecting, connect them surely, referring to the table below.
PRINT
PRE
POST
After turning off the sub and main power switches, unplug the power cord. Make sure to take 15
minutes before restarting the operation. It is very dangerous if sleep mode functions mistakenly
during the operation.
Additionally, if electric charges are still remaining, it may cause damage to electronic parts or the like.
Outside of Left electrical box cover
POST
Inside of Left electrical box cover
PRE PRINT
POST
PREPRINT
Widen the hook
Mounting adapter
Temperature controller
Wiring diagram
Terminal diagram viewed from the
backside of controller
POSTPREPRINT
Terminal No. Wire marker Terminal No. Wire marker
1 A36 6 ––
2 A37 7 ––
3––8RT3
4 17 9 RT33
51610––
Terminal No. Wire marker Terminal No. Wire marker
1 A33 6 ––
2 A34 7 ––
3––8RT2
4 15 9 RT22
51410––
Terminal No. Wire marker Terminal No. Wire marker
1 A30 6 ––
2 A31 7 ––
3––8RT1
4 13 9 RT11
51210––
To Next Page
Loading...
