MIMAKI SWJ-320 S2 - Page 179

© 2013 MIMAKI ENGINEERING CO.,LTD. 6.9.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Drying unit relations > Warm Breeze Fan assy.
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.
6.9.1 Warm Breeze Fan assy.
 Work procedures
1. Turn off the main power supply and remove the power plug
from the main body.
2. Turn off the main power of drying fan unit, and then unplug the
power plug from the drying fan unit.
3. Unscrew the screws of both sides of the drying fan unit, and
remove the drying fan unit from the main body.
4. Remove the cable duct lid of the back of drying unit.
5. Disconnect the connector of the warm breeze assy. from the
relay connector.
6. Remove the screw, and remove the warm breeze fan assy..
7. Reverse the disassembly procedure for reassembly.
Warm breeze fan assy. (x9)
Unplug the power plug
Screw(x2)
Drying fan unit
Screw(x2)
When the drying fan unit is removed, be sure to
work with more than two persons, paying atten-
tion not to drop it nor damage the surroundings.
Warm breeze fan assy.
Connector
Screw(x2)
Warm breeze fan assy.