© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.13 P.2
4.2.13 MOTOR CURRENT
1
2
3
4
5
6
7
8
Procedures for Y MOVING ADJUST
1. Select [MOTOR CURRENT] -> [Y MOVING ADJUST] from
the operation menu.
[]/[]: Changes items
[ENTER]: Finalizes (To the next compensation screen)
2. Input the following test conditions and execute the function.
Speed (S): 5 to 10 mm/s
Acceleration (A):1.0 G
Length (X): About 50 to 100 mm
3. Adjust the value so that the hunting sound during the Y motor
running is minimized.
Check the hunting sound of the Y motor at right side.
4. Press [END] several times to complete the Y-axis motor current
adjustment.
[]/[]: Changes the value
[]/[]: Moves
[ENTER]: Executes
[END]: Returns
<LOCAL. 1> [#01]
FUNCTION
#ADJUST <ENT>
#ADJUST
MOTOR CURRENT <ent>
#MOTOR CURRENT
Y MOVING ADJUST <ent>
#Y MOVING ADJUST
S=50 A=0.10 X=100
Y-axis continuous drive
(Y-axis motor drive)
#Y MOVING ADJUST
140 ( 0 )
(Carriage out)
To check the hunting sound, return to LOCAL mode
by pressing [END] and operate a JOG key.
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > MOTOR CURRENT
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver.
1.20
Remark
1.0
To Next Page
Loading...
