MIMAKI TS34-1800A - Page 170

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.3 P.1
1
2
3
4
5
6
7
8
6.2.3 Pump Motor
 Work procedures
1. Remove the station cover U34.
2. Remove the pump tube connected to the cap head.
3. Remove the pump motor assy connector and then remove the
pump assy. (Refer to 6.2.4)
4. Remove the stepping motor together with the pump assy.
5. Reverse the disassembly procedure for reassembly.
Protrude the pump tube of the discharge side from tube end by
5 to 9 mm.
Pump Motor
Take care not to pollute the surroundings with waste
ink or washing liquid.
Pump Motor
Screw
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Pump Motor
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.