MIMAKI TS34-1800A - Page 191

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.3.5 P.2
6.3.5 Linear Encoder Scale
1
2
3
4
5
6
7
8
6. Peel off the left end (the side with two holes) of the protection
film on the new linear encoder scale.
7. Mount the scale hook on the linear encoder scale so that the
surface where the protection film is stuck faces to the Y bar
side.
8. Engage the scale hook with the scale base L through a spring,
and mount the linear encoder scale while peeling off the
protection film.
9. Reverse the disassembly procedure for the subsequent
reassemblies.
While at work, be sure not to attach fingerprints or oil
to the linear encoder scale. Also, pay attention not to
break or scratch it. (If contaminated, clean the scale
with a neutral detergent.)
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Linear Encoder Scale
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.