© 2011 MIMAKI ENGINEERING CO.,LTD. 6.3.6 P.1
1
2
3
4
5
6
7
8
6.3.6 Wiper Unit
Work procedures
1. Remove the following covers.
• Station Cover Right
• Station Cover U34
2. Remove the screws, and remove the wiper unit from the base.
3. Release the clamp under the station and disconnect the wiper
motor connector.
4. Disconnect the wiper origin sensor connector.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Wiper Unit
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver
1.20
Remark
1.0
To Next Page
Loading...
