MIMAKI TS34-1800A - Page 255

© 2011 MIMAKI ENGINEERING CO.,LTD.
8.4.1 P.3
8.4.1 #ADJUST
1
2
3
4
5
6
7
8
#ADJUST
MOTOR CURRENT <ent>
#MOTOR CURRENT
STOP ADJUST <ent>
X = 140 Y = 140
( 0 ) ( 0 )
#MOTOR CURRENT
X MOVING ADJUT <ent>
#X MOVING ADJUT
S=10 A=0.10 X=100
#X MOVING ADJUT
140 ( 0 )
#MOTOR CURRENT
Y MOVING ADJUT <ent>
#Y MOVING ADJUT
S=50 A=0.10 X=100
#Y MOVING ADJUT
140 ( 0 )
#ADJUST
SERIAL No. <ent>
#SERIAL No.
00000000
#ADJUST
DEALER No. <ent>
#DEALER No.
00000000
#ADJUST
DEFAULT SET <ent>
#DEFAULT SET
SETUP PARAMETER <ent>
SETUP PARAMETER
INITIALIZE OK? :ent
#ADJUST
EXCHANGE PARTS <ent>
#EXCHANGE PARTS
REGISTRATION <ent>
#EXCHANGE PARTS
PARTS :PUMP
*PUMP
00.00.?? : No.1
Various parameters
#DEFAULT SET
HIPPING SETUP <ent>
ToSHIPPING condition
Set up OK ? :ent
#EXCHANGE PARTS
PARTS :CAP
*CAP
00.00.?? : No.1
#EXCHANGE PARTS
PARTS :DUMPER
*DUMPER
00.00.??:No.1-A
#EXCHANGE PARTS
HISTORY <ent>
*HEAD
[ 0] 06.10.10 : No.2
** There is no **
** HISTORY. **
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[] / []
[] / []
[] / []
[] / []
[] / [][] / []
[] / []
Only at the factory
∗When there is no history
#ADJUST
DAMPER DISCHG <ent>
#DAMPER DISCHG
:DISCHARGE
#DAMPER DISCHG
START :ENT
Start discharging ink
#DAMPER DISCHG
:FILLUP
#DAMPER FILLUP
START :ENT
Start filling up ink
[FUNCTION],
[] / []
[] / []
[END] stops discharging.
[END] stops filling.up
R.1.0
MAINTENANCE MANUAL > Operation Flow > Service Mode > #ADJUST
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.