MIMAKI TS34-1800A - Page 66

© 2011 MIMAKI ENGINEERING CO.,LTD. 3.2.1 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Workflow > Driving Parts > Replacement of the X-axis Motor
Model TS34-1800A Issued 2011.10.17 Revised F/W ver. 1.20 Remark
1.0
Rev.
3.2.1 Replacement of the X-axis Motor
 List of replacement procedures
Item Work operation Description Ref.
Covers
1.

Removal of covers, etc. Remove the maintenance cover L, X pulley cover and left
cover.
6.1.1
X-axis Motor
2. 
Removal of the X-axis motor. Remove the X-axis motor. 6.3.1
3.

Mounting of the X-axis motor. Mount the X-axis motor.
Adjustment
4. 
Adjustment of the belt tension Adjust the tension of the belt.
5.

Adjustment of the motor current If a hunting noise occurs while the motor is being driven,
adjust the X-axis motor current.
4.2.13
Covers
6. 
Mounting of the covers. Mount the covers that have been removed. 6.1.1
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
X-axis Moter